Bath and Shower Kit

Preparation:

• Use rubber gloves to avoid contact with the skin.
• Dilute MB-3 Soap & Mineral in a proportion of 1 part MB-3 to 2 parts warm water with the 32oz spray bottle.
• Use MB-5 as needed before during and after MB-3 or MB-9.
• Test on a spare piece or in an inconspicuous area first.

Directions:

Step 1: MB-3

1. Liberally apply with a sponge and allow to stand without letting the solution dry.
2. Once the soap scum begins to break up, scrub lightly with a scrub brush or plastic scouring pad.
3. Rinse thoroughly.
4. Repeat these steps if necessary.

Step 2: MB-9

1. Spray on liberally.
2. Allow mold or mildew stains to disappear, and be careful to not allow the product to dry on the surface.
3. Rinse thoroughly.
4. Repeat these steps if necessary.

Step 3/As needed: MB-5

1. Hold the sprayer about 6 to 8 inches from the surface.
2. Spray a light mist over the area to be cleaned.
3. Let the product sit for approximately 30 seconds.
4. Buff the surface dry with a paper towel or a clean white cloth.
5. When the towel becomes wet, discard it and start with a fresh one.